14
2024
-
08
Several Problems Related to Laminating Machine
A laminating machine is equipped with 4 non-stick cloth. At the end of each application, it is not necessary to reuse it many times immediately. It is just to put it aside and wait for the non-stick cloth to be completely refrigerated, and then the EVA on the non-stick cloth will be completely eliminated and tidy. The non-stick cloth will stick to its original color.
1. Normal use of glass cloth
OneLaminating machineOn the configuration of 4 non-stick cloth. At the end of each application, it is not necessary to reuse it many times immediately. It is just to put it aside and wait for the non-stick cloth to be completely refrigerated, and then the EVA on the non-stick cloth will be completely eliminated and tidy. The non-stick cloth will stick to its original color. If the EVA on the non-stick cloth cannot be completely cleaned up, this EVA will stick to the laminated glass of the lithium battery module when it is reapplied. At this time, no matter what kind of EVA cleaning is left on the laminated glass EVA particles. When solar panels are used outdoors, the EVA particles will melt again and stick to the laminated glass. And suck the dust on the laminated glass. This dust cannot be removed. Sometimes dust will block the battery, which will produce a long-term hot spot effect.
2. Reasonably use the sealing data of the outer frame
The sealant must be applied when the outer frame of the solar panel is modified. Some enterprises press the EVA strip on the concave groove of the outer frame to carry out sealing. And the EVA was melted with a hair dryer. If EVA is used to seal the outer frame, be sure to put the solar panel with the modified outer frame into the curing oven for drying. Otherwise, in outdoor applications, EVA will continue to melt under sunlight absorption a lot of dust. In addition, the sealant must not be applied to colored plate collagen fibers, otherwise this kind of melanin will gradually spread to the EVA in the solar panel, and the solar panel will fade after one year of application.
3. Normal use of vacuum pump
Laminating machineIn the usual maintenance, the important maintenance stage is the maintenance of the ultrafiltration device. WhenLaminating machineAfter a period of application,Laminating machineThe vacuum value will be reduced. And reduced to a certain level, solar panels will appear bubble. Therefore, it is stipulated to check whether the mechanical pump is less oil on a daily basis. Check whether the oil volume of the mechanical pump reaches the dialog oil baseline under the working attitude. If it is insufficient, it should be supplemented, but not too much. The second is that after a period of application, the vacuum pump oil has just begun to turn cloudy or black. It is stipulated to change the oil of the mechanical pump and clean the mechanical pump to eliminate the colloidal solution-like dirt sucked in the mechanical pump.
Keywords: computer numerical control panel saw
Laminating machine
undefined
WeChat Consulting
HotLine
Business docking E-mail
Company Address
No.2,2nd West Ring Road,Xichong,Lunjiao,Shunde,Guangdong,China